Flash for CANON cameras - YongNuo YN200 KIT with TTL

Flash for CANON cameras - YongNuo YN200 KIT with TTL Powerful TTL flash Yongnuo YN200 is a new flash from Yongnuo that combines compact size, good battery life (up to 500 flashes on a single battery charge) and high power (200 J). The YN200 is equipped with an open-type lamp, which allows you to get the most out of the flash with any light modifier, and a small reflector is included for working with hard light. The flash is equipped with a built-in receiver of the new YN560-TX PRO radio synchronizer. It can be used to remotely control the YN200 in TTL mode. The same transmitter is installed in the YN862 flash in Master mode - it can also fully control the YN200 flash. In manual mode, the YN200 flash can be controlled by the YN560-TX (II) transmitter and flashes with 560TX master mode - for example, the YN560IV. In addition to radio receivers, the flash has an optical Slave Canon/Nikon (slave flash mode) and a light trap S1 -S2. This means that the YN200, if necessary, can be used even without a transmitter, using the built-in or third-party flash. The flash body is made of high-quality plastic with slots for effective cooling of the device. There are 2 1-4" female metal threads on the body that will allow you to mount it in two orientations on any studio stand or tripod using the 1-4" threads. But more importantly, the YN200 can be installed in a universal S-Type holder. Thanks to this, the flash can be conveniently used with photo umbrellas, EASYbox and any other Bowens attachments and softboxes. Under the rubber plug there are microUSB connectors for firmware updates and a 3.5mm mini jack for flash synchronization using a cable. At the end there is a display that displays the flash operating parameters, its power, pulse speed and battery charge level. There is a light trap above the display to receive signals from other flashes. The flash is powered by a powerful 14.4V/2900mAh lithium battery, with which the flash can fire up to 500 pulses at full power, with a recharging speed of 0.01-2 seconds. The battery is quick and easy to install and remove. The YN-C2900 charger can operate from power sources with voltages of 5, 9, 12 and 15V, with a maximum current of 2A. Thus, you can use your smartphone charger, POWERBANK or car charger with a Type C connector. Technical characteristics of the Yongnuo YN200 flash: Flash power: 200 J Guide number: 60 ISO100 (using reflector) Color temperature: 5600 K Power supply: lithium battery 14.4V 2900mAh Recharge time: about 0.01-2sec Power adjustment: 1 -1 ~ 1 -64 Number of puffs at full power: up to 500 Synchronization modes: YN560, optical transmission mode (SC / SN), S1, S2, 3.5mm sync cable Flash mode: TTL? Manual? Multi Firmware Upgrade: Micro-USB Dimensions: About 205*78*53mm (without lamp) Weight: