NANOPROTEC MKPP 100 additive

Nanoprotec MKPP 100 is designed to protect against wear, prolong life and restore the characteristics of mechanical gearboxes, including robotic gearboxes of any design, as well as for gearboxes, gearboxes, main gears of cars.

Efficiency: ISK MKPP 100 (additive) partially restores the dimensions and geometry of worn parts, optimizes the gaps in friction pairs, allows you to keep a denser oil layer on the surface of the parts. This allows:

Facilitate shifting;

Optimized gaps allow for easier and more precise gear shifting;

Reduce noise and vibration;

Optimization of gaps and restoration of bearings reduce noise and vibration when the gearbox is operating;

Increase coasting. The retention of a denser oil layer on the surface reduces frictional losses, which increases the coast: the vehicle travels in a neutral gear;

Protect the transmission from wear and tear;

The formed layer on the friction surfaces and the dense oil layer significantly reduce wear and increase the service life of the unit.

The order of application: The procedure for processing mechanical and robotic gearboxes is as follows:

Warm up the transmission to operating temperature (normal operation).

Stop the engine.

Thoroughly mix the contents of the vial so that the sediment at the bottom is distributed throughout the volume of the liquid.

Fill the composition in the gearbox through the oil filler hole of the unit.

Immediately after adding the composition, make a trip on the car for 20-30 minutes in normal operation mode. It is necessary to operate the car on each gear at least 100-150 meters.

Immediately after treatment, the car can be used as usual.

For the long trouble-free operation of the gearbox, it is recommended to use the ICK MKPP 100 after each scheduled replacement of the gear oil.

In gearboxes and manual gearboxes, if the oil is fresh (up to 10,000 km of run), Nanoprotec MKPP 100 can be used in one step without changing the oil at the rate of 60 ml per 1 liter of oil for the worn out mechanism, 30 ml per 1 liter of oil For a new mechanism.

ISN Nanoprotec MKPP 100 the additive is compatible with all gear oils, with the exception of ATF, PSF

#motor