Intelligent lubricant composition (NSC) NANOPROTEC ACTIVE DIESEL (additive)

Intelligent lubricant composition (ICS) Active Diesel is designed to protect against wear and maintain the performance of diesel engines of cars with mileage up to 50,000 kilometers. Can be used for forced and turbocharged engines. The effectiveness of ICS Active Diesel creates conditions in which the surfaces in the engine friction points are coated with a nanomodified protective layer that has a low coefficient of friction and high wear resistance. This layer partially restores the dimensions and geometry of the worn parts, optimizes the gaps in the friction pairs, retains more oil on the friction surfaces.

This provides the following effects from the application of the formulation:

Increase in life - the protective layer significantly reduces the wear rate of the most loaded friction parts that determine the life of the engine;

Protection at high loads - the protective layer significantly more effectively prevents the wear of friction parts at elevated loads due to structural features (microhardness and microelasticity) and retaining more oil;

Start-up relief and protection during "cold start" - the treated surfaces are able to hold the oil layer in the long idle time. This facilitates the completion of the first revolutions and prevents an increased wear of the engine during oil starvation at the time of launch, which is especially important at a negative ambient temperature;

Protection with active driving - the treated surfaces retain a denser oil layer that reduces wear and compensates for oil starvation at the time of a rapid engine speed set;

Fuel economy - the protective layer and the oil it holds seal the gaps in the cylinder-piston group, which compensates for compression, improves combustion of fuel, reduces frictional losses. This reduces fuel consumption by 6-8%;

Reduction of vibration and noise - restoration and equalization of compression on the cylinders leads to smooth operation of the engine. In addition, a dense layer of oil softens the rearrangement of the pistons. All this reduces vibration and noise in the engine;

Reduction of toxicity - restoration of compression and optimization of gaps in the cylinder-piston group ensure a high-quality combustion of fuel, which leads to reduced toxicity of exhaust gases.

Instructions for use: Engine processing Nanoprotec Active Diesel The diesel is produced in three stages.

I stage: add Additive Nanoprotec Active Diesel in the working oil for 500-1000 km before the replacement; Regular operation of the car before the scheduled oil change (at least 500 km).

II stage: add ISK Nanoprotec Active Diesel in the new oil; Obligatory maintenance: oil change, replacement of oil and air filter. Regular operation of the car before the scheduled oil change. After 20-30 thousand km, processing of the Nanoprotec Active Regular engine is recommended.

At each stage, it is necessary to add the composition to the engine oil according to the following procedure:

Warm up the engine to operating temperature (normal operation).

Stop the engine. 3. Thoroughly mix the contents of the vial so that the sediment at the bottom is distributed throughout the volume of the liquid.

Pour 1 bottle of ICC into the oil filler neck of the engine. (In case the volume of the oil system is more than 7 liters, two bottles must be poured).

Immediately after adding the composition, drive the car for 20-25 minutes in normal operation mode.

After the end of the procedure, the car can be used as usual. Reuse of Nanoprotec Active Diesel is recommended after 100 000 km of run after the initial treatment. For turbocharged and boosted engines it is recommended to reuse after 50 000-55 000 runs. To achieve the full level of protection of the car, it is recommended to handle all the nodes and mechanisms of the transmission, fuel pump, power steering and chassis

#motor