The holder for the Oxford CLIQR Cycle CLIQR smartphone is a simple device which can be installed on your rod or a wheel if it has diameter of 25.4 or 31.8 mm that most of all extends to those which have aerodynamic shift. In a box you receive fastening, two sticky adapters, silicone inserts for protection of a core / wheel and two cable couplers. Place fastening on a core or a rod, then wrap up cable couplers around both ends of fastening and through guides and tighten. Further remove a substrate from the adapter and attach it to phone. It is worth spending a little extra time to make it it is correct because if it goes not so, you do not receive it again. To use fastening, at first it is necessary to attach one of adapters to the back panel of phone or a cover. The adapter uses the VHB adhesive tape from 3M and has very strong communication. After connection to phone it will not move a little without big effort. It is very simple to place phone in fastening, by means of the small latch which is fixing the adapter, and reliably holding it on the place. To delete number, it is enough to press the button to open a tab. The holder is compatible to the majority of phones, covers for phones, GPS devices and compact an action chambers. If you want to use the phone by bicycle, Oxford CLIQR is the simple, safe decision for acceptable money. The holder is compatible to the majority of phones, covers for phones, GPS devices and compact an action chambers. Technological features: The adapter of the device uses high-quality glue 3M the Double mechanism of blocking with the failsafe Device system can change between album and portrait orientation of Harakteristiki: Production Great Britain is suitable for diameters of 31.8 mm and 25.4 mm