Owners of aquariums constantly ask a question whether water parameters meet necessary standards? The modern device from the German company JBL considerably will simplify the solution of this task.

for testing of fresh water in aquariums, open freshwater reservoirs or just in a water supply system.

only a few minutes, and gives a full picture on composition of water in your aquarium.

All you need to do is is to install the application which is in a device set on the smartphone, to wet a test strip in that water which parameters it is necessary to estimate and scan the color chart on a test strip by means of the smartphone. The program won't just show values which should be analyzed in addition, and and will give an assessment to a condition of water: "well", "so-so", "badly".

the Principle of measurement rather simple, but results shows rather exact. It is possible to learn quickly and CO2, total hardness of water, alkalinity, рН. Whether also the analyzer shows chlorides, nitrites, nitrates exceed admissible norms.

• Water analysis and diagnostics by means of the smartphone: simple and reliable control of parameters of water in freshwater aquariums. Defines the total and carbonate hardness, рН, nitrites, nitrates, chlorine, CO2 calculates.
• New generation of tests for water: download the free application of ProScan, dip a test strip in water, put on the color chart for the analysis. After scanning of the color card, values will be defined.
• Fast diagnostics - exact results: parameters are displayed in the form of numerical values and also analyzed (well, so-so, it is bad). Additional instructions on optimization for freshwater aquariums and ponds.
• It is compatible to iPhone and iPad: the version of IOS 9.0 or more late is required, Android of version 5.0 or is higher also the camera with an auto focus.

of the Recommendation about application:
Press the Start-up button and ship strips for the analysis for 2-3 seconds in water. Shake surplus of water. Then place a strip for the analysis on the color card and wait until time expires. Photograph all color card with a test strip to receive results.

Note: the test strip can be used only for one measurement. Repeated scanning of a strip will result in other values as as chemical reaction on a strip goes continuously.

At extraction of a test strip from water can't shake from it water, holding vertically because in this case wet paints will get on other color fields. Drops have to flow down at horizontal position of a strip, it is necessary to shake carefully. If not to allow drops to flow down on color fields, they will reflect too strongly light and will result in inexact results. Ideally the test strip on the color card should be photographed at a daylight. But uniform lighting, without partial hit of a shadow and direct sunlight is even more important (in that case colors on the color card will be covered differently).

Producer: JBL, JBL GmbH & Co. KG, Germany