The SAE 10W40 Motul 836521/4T 5100 engine oil from the famous French producer, 160 years famous for the lubricant car products - motor- and the water transport. Motul oils are produced for concrete models of motors. Ania consist of hi-tech air which protects engines from surplus loads and changes of weather. Resistance of an oil film to a gap makes 22 t on square centimeter that is an absolute record. The Motul engine oils passed the most serious tests, and with success are used in extreme sports. Semi-synthetic oil for cross-country race and enduro By production of Technosynthese® oil is used esters (ester) which form an oil film, resistant to a gap. Ania belong to class 10W-40, this viscosity is the ode from the most widespread recommendations from producers of motorcycle engines. Thanks to additives the wear of the motor considerably decreases and if to consider resistance to shift, then this oil will become best "friend" of the transmission, will protect it from loadings and considerably will prolong service life. The cross-country, enduro and a trial with dry coupling or being in oil "bathtub" will be suitable as for roads, and off road terrain, for four-cycle motorcycles. The best protection of engines Motul Oil 836521/4T 5100 guarantees complex protection of the motor of your motorcycle. It will provide durability of a box of speeds. Differs in resistance to a rupture of a film even at the most high temperature. In an oil bathtub the coupling works ideally, speeds switch easily and simply. Also by production was it is reduced percent of content of phosphorus and availability of sulfur is minimized not to do harm to the environment. It is authorized to combine oil with mineral and synthetic oils. If you the owner of the off-road motorcycle with the four-cycle engine, we advise to buy this oil. Characteristics: Category: API SL/SJ/SH/SG Test: JASO MA No. M033MOT055 Class of viscosity, SAE J 300: 10W-40 Density at 20 °C (68 °F), ASTM D1298: 0.871 Viscosity at 100 °C (212 °F), ASTM D445: 13.9 mm2/s Viscosity at 40 °C (104 °F), ASTM D445: 91.8 mm2/s Index of viscosity, ASTM D2270: 154 Point of change of fluidity, ASTM D97: -33 °C / -27 °F Point of flash, ASTM D 92: 218 °C / 424 °F Alkaline number, ASTM D2896: 8.2 mg KOH/g of Proizvodstvo: France