NANOPROTEC TM CLEANER OF VENTILATION SYSTEMS is designed for disinfection and removal of odors from heating and air conditioning systems in the cars interior, prevention of bacterial infections. For self-use, does not require special knowledge, skills or tools.

Effect from application:

Eliminates at least 95% of bacteria and microorganisms. The purifier has antimicrobial activity against a wide range of Gram-positive and Gram-negative bacteria, including: Staphylococcus and Escherichia coli. The cleaner was tested for compliance with the safety and efficacy standards of disinfectants (P 4.2.2643-10);

Neutralizes unpleasant odors. The cleaner effectively removes from the ventilation system smells of tobacco smoke, dampness and odors of another origin;

Refreshes the air. The essential oil of eucalyptus fills the air with fresh aroma;

To maintain the effect of disinfection, it is recommended that the cleaner of the ventilation systems be regularly applied: approximately once every three months. The

Application: One package is enough to handle one car. Processing is carried out in a closed car in the absence of people. Before using the product, make sure that the container is warm, the temperature should be between +8 C and +28 C.

For disinfection and deodorization of ventilation systems, it is necessary to thoroughly clean the interior of the car, and then perform the following actions:

Start the car engine.

Set the recirculation mode in the car.

Turn on the air conditioner (for cleaning the air conditioning system) or set the minimum heating mode (for cleaning the heating and ventilation system). In the presence of climate control, put it into manual mode.

Set the minimum temperature and minimum fan speed.

Install the airflow through the dashboard and make sure that the ventilation openings are open. Shake the can with the cleaner. Install the cylinder between the front and rear seats, in the middle (the cleaner box can be used as a cylinder holder when it is installed in the cars interior, for this, a special bursting perforation is provided on the box)

Warning: do not lean over the cylinder! Do not direct the jet of spray into the face!

Press firmly until the click of the spray button, the spray will begin to spray from the cylinder up.

Exit the car, slam the doors and wait 10 minutes.

At the end of the sprayer, open all doors of the car for 5 minutes. In the salon do not go!

Switch off the engine.

Let the salon be ventilated with the doors open for 10 minutes.

PRECAUTIONS: FIRE-FIGHTING! Protect from direct sunlight and heat. Do not spray near open flames and hot objects. The cylinder is under pressure! Do not disassemble or give it to children. Avoid contact with skin, eyes, respiratory system. Do not bend over the cylinder when the spray button is pressed. Car treatment should be carried out only outdoors (outdoors) using, no more than one balloon cleaner for one car. At service stations, car handling should be carried out in conditions of sufficient supply and exhaust ventilation when working with solvents, paints and alcohols.

   Environmental precautions: Do not open or incinerate the cylinder even after use. After use and expiration date, the product is disposed of as household waste. Recycle the fully used balloon.

   First-aid measures: In case of non-observance of precautions, signs of irritation of the mucous membranes of the eyes and respiratory organs may appear. If irritation of the upper respiratory tract occurs, go to fresh air or a ventilated area and drink warm milk with baking soda (1 teaspoon per glass of milk). In case of contact with eyes, rinse immediately with warm water for 10-15 minutes. If necessary, consult a doctor. After contact with skin, wash it off with water.